JA-152KRY Control panel with radio module and 4G communicator LITE

Installation should be done by a trained technician with a valid certificate issued by an authorized Jablotron distributor.

The required settings and system parameters are programmed via MyCOMPANY. The setup is intuitive and very simple even for novice installers.

Control panel with radio module and 4G communicator LITE

JA-152KRY Control panel with radio module and 4G communicator LITE

The JA-152K control panel offers:

  • up to 31 wireless peripherals
  • up to 32 users
  • up to 4 sections
  • up to 2 programmable PG outputs
  • built-in acoustic indication (80 dB/m) of tamper, intrusion and fire alarm, which may be utilized as a wireless doorbell in combination with the JA-159J wireless doorbell button

Technical specifications

Installation type Fixed installation
Control panel power supply ~ 110 – 230 V/50 – 60 Hz, max. 0.28 A with F1.6 A/250 V fuse, security grade II
Electrical power / current Max. 23 VA / 0.1 A
Protection class II.
Back-up battery 3.7V, 5000 mAh, Li-Polymer
Low battery backup voltage (fault indication) ≤3.5V
Maximum battery recharge time (80% capacity) 72 h
Maximum number of sections 4
Maximum number of devices 31 devices + 31 remote controllers
Maximum number of users 32
Max. number of PG outputs 2
Alarm connections Wireless connection– unspecified wireless connection, Jablotron wireless protocol
Classification of Alarm device Security Grade 2 / Environment Grade II
@ According to standards EN50131-1, EN 50131-3, EN 50131-6, EN 50131-5-3, EN 50131-10, EN 50136-1, EN 50136-2
@ Environment Indoor general
@ operational temperature range / humidity range -10 °C to +40 °C / 75% RH without condensation
@ power supply Type A – primary mains power supply with a powered back-up battery.
@ event memory capacity approx. 7 million events, including sources and timestamps.
@ system reaction to loss of device communication Fault or Tamper – Dependent on selected profile
@ wireless communication within 2h (from last communication)
@ Wireless communication within 20min blocks section setting
@ system reaction to incorrect code entry Alarm after 10 wrong code entries, dependent on selected profile, the system will be locked for ten minutes.
@ ATS classification Supported ATS classes: SP2 – SP5,
SPT: type Z
Operation type: Pass-Through
GSM2201MD SP3 – SP5 (JABLO IP, ANSI SIA, DC-09)
@ ATS Alarm transmission protocols JABLO IP
@ ATC security against substitution and protection of information Jablotron protocols: proprietary AES encryption with a minimally 128 bit key ANSI SIA DC-09.2012 protocol with 128 bit AES encryption
Dimension 182 x 132 x 58 mm
Weight with battery / without battery 510 g/430 g
Based parameters of the JA 111R module 868.1 MHz, <25 mW, GFSK <80 kHz
Radio emissions ETSI EN 300 220-1,2
EMC EN 50130-4, EN 55032, ETSI EN 301 489-1, ETSI EN 301 489-3
Safety conformity EN IEC 62368-1
Conditions of operation ERC REC 70-03
Certification body TREZOR TEST (no. 3025)

Similar products

JA-102KRY JABLOTRON Mercury Alarm system control panel

Installation should be done by a trained technician with a valid certificate issued by an authorized Jablotron distributor. The required settings and system parameters are programmed via MyCOMPANY. The setup is intuitive and very simple even for novice installers.